Please fill all required fields
 
    Shunt Resistor - and current/voltage calculator
    Resistance
    Current mA
    Voltage
    Enter the resistor value and the current
    to calculate the voltage drop generated
    www.omniinstruments.co.uk
    To calculate logger input scaling enter the minimum and maximum signal voltage or mA and the range in engineering units this corresponds to.
    Then enter the actual measurement range of the logger in volts or mA. Signal span, signal / engineering unit zero point and engineering units per
    volt/mA will be calculated. All signal values must be entered in the same units i.e V and mA cannot be mixed.
    To calculate voltage and engineering units resolution enter the logger resolution - e.g 8 bit = 256, 10 bit = 1024, 12 bit = 4096, 16 bit = 65536
    Logger Input Scaling Calculator
    Sig Min Sig Max Sig Span Eng Min Eng Max Eng Unit /V/mA Eng 0 point V/mA LGR Min V/mA LGR Max V/mA
    Eng Units Span LGR Res V/mA Res Units res Measured Voltage Eng Units Value Eng Scale Min Eng Scale Max

     

       
    		Powered By SpreadsheetConverter